The two-part medium-viscosity formulation can be room-temperature or heat cured and has a Tg of 65°C. Tra-Bond 2143D has low-moisture absorbance and lapshear strength of 2,200 psi. It bonds with most ...

Air bubbles pose a significant risk in sensor encapsulation, potentially compromising protection and reliability. Master Bond addressed this by implementing rigorous degassing protocols prior to ...

Point-One Structural Polyurethane Adhesives are fast-curing two-part adhesives that form strong, durable bonds in as little as 10 minutes. They are resistant to moisture, fuel, many solvents, and ...

For medical device manufacturers, selecting the right adhesives and developing the correct bonding procedures—including surface preparation, adhesive dispensing, and curing—are critical parameters in ...

A methacrylate adhesive provides a combination of high strength, fatigue endurance, impact resistance, and toughness. Developed for use on metal and other substrates, the MA820 two-part adhesive ...

While some adhesives are single-component and cure via other mechanisms like UV or heat, Scott Bader’s Crestafix, Crestabond, and Crestomer adhesives consist of two components and cure via ...

A new two-part adhesive system is said to offer thermal conductivity in excess of 22 BTU-in./ft.2-hr.-°F. The EP21AN epoxy adhesive system is an electrical insulator with a dielectric strength of ...

“The SG100 Series is part of SCIGRIP’s comprehensive offering of high-performance marine adhesive technologies,” explained Kirk Miller, SCIGRIP’s regional sales manager. “The newly reformulated SG100 ...

PPG Industries, Inc. PPG has announced the addition of two adhesives to its aerospace portfolio, namely PPG PR-2940 epoxy syntactic paste adhesive (ESPA) for bonding aircraft's internal structures and ...

The adhesive readily bonds to itself, metals, silica, sapphire, alumina, ceramic, glass, and plastics. It is resistant to salt solutions, mild acids and alkalis, and chemicals such as petroleum ...

A two part adhesive system, EP21AN specifies a thermal conductivity in excess of 22, dielectric strength greater than 400 V/mil, and a volume resistivity greater than 1,013 Ohm-cm. The adhesive with a ...