I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...
I have been using TI MCU tms570ls3137 and want to utilize virtual EEPROM on BANK7. so i have proceeded below steps I have generated FEE driver code through Halcogen and included FAPI library. while ...
My customer is using the eeprom function on the TMS570LS0032. They found that serval chips cannot read and erase the eeprom. They use TI's SDK function to read and erase the eeprom, and the function ...
I'm using CC2340R5-Q1 MCU and SDK simplelink_lowpower_f3_sdk_8_10_01_02. I use the basic_ble project and integrate i2ctarget into it. If I2C receives I2C data, it ...
We use gmake tool to build our AM62Ax project in windows operation system, sometimes the compiler report error log as the screenshot show,but if we try to rebuild the ...
Here is what we want to achieve when evaluate on TI EVM. We have an application running on Linux A53 core and we want to update it each time we power on the EVM. Using EMMC boot media of EVM, after ...
we use the LM5164 chip on many electronic boards and we are very satisfied. I noticed that typically the impedance of the VIN pin (referred to the GND pin) is around 9MΩ. The measurement is made with ...
Hello, my device is of HSSE type. R5 was previously developed under version mcu_plus_sdk_am62x_08_06_00_18. The compiled firmware will finally be signed by the ...
After sending the calibration command, I put the ADS in short-circuit mode and performed some acquisitions to check the calibration. The measured values are not very ...
does someone has an example for an U-Boot "sspi" command to communicate with an OSPI NOR flash? I would like to read some status information from the XSPI/OSPI NOR flash used for booting on my board ...
I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...
I m trying to connect LP-MSPM0G3507 eval board by using xds110-et on board debugger but when i connect to board to pc , i m getting this error attached ...