I choose OPA365 because it have IN/OUT Rail to Rail and high Current supply with High Bandwidth, good offset voltage. The R1 1ohm Resister is placed for driving high capacitive load. However I'm ...

Hi, Uttam. :) I am using the BP-DAC11001EVM and MSP-EXP432E401Y. I am powering the eval board with +/-15V, 5V for ref power, and 5V for VDD. I am measuring the output over time, and I see a very low ...

I am stacking two BQ76952 ICs and interfacing them to an MCU using SPI. IC-1 is powered from cells 1-16. IC-2 is powered from 17-19. Both ICs are interfaced with MCU using a single SPI module and ...

I have a situation where 4 of the ADC3664 devices will be used in a design. The devices will operate from the same input clock source and are intended to be synchronous. My question is: can the FPGA ...

I am working on the Universal Motor Control Lab project, with the f28p65x LaunchPad and the DRV8353RS-EVM boards. I follow the instructions of the SPRUJ26 user's guide I have passed DMC_LEVEL1 up to ...

I am trying to connect and communicate with my AWR6843ISK EVM or run the MMWAVE demo visualizer. My setup is as follows - AWR6843ISK board by itself(not plugged into a carrier board), USB cable ...

Programs such as UBRT-2300 and BE2Works can do unseal bq2060 without unsoldering the eeprom. Why can't EV2200-60 do this? It has been a long time since the end of production of bq2060, please open the ...