XCP is a common requirement from automotive OEMs. I’ve found that Implementing XCP-on-CAN for a C2000 device is far from straightforward and there doesn’t seem to be much information publicly ...

I wondered which parameters I can change (except parameters of my motor) during my own tuning process when using hvkit with F28069M ISO Control Card? When I was ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

Hello I have a question about changes in PRU FW between SDK Linux RT version 8.2 and 9.1. When I connect IDK PRU ICSSG port to NIC which starts sending frames after linkUp. There is different behavior ...

I am currently using Hercules_Ethernet_Bootloader, I am using CCS 9.1 . When using Uniflash to burn Build-TMS570LC43x-tftpBoot.out, an error is reported. How can I ...

I need some details/clarifications: - looks like txQueue and rxQueue are static arrays defined in both int_comm_drv.c and meter_comm_drv.c? - Which .c file does the code that is shown above correspond ...

I flashed an image onto my custom board, but it hangs with the message "Waiting for root device PARTUUID=e7dbd504-c47a-493d-a1d4-aa34686b4b5b...". Could you help me troubleshoot this issue? If ...

I am working with adding INA3221 in my schematic. I am wondering about the address pin. There is only one address pin Ao. The pin Ao can be attached to GND, VS, SDA, or SCL. Does it means only four ...

Related to this older thread, I'm also trying to get uvc-gadget to work, on a J784S4XEVM this time. My script is listed below. #! /bin/sh GADGET_DIR="/sys/kernel ...

Texas Instruments (TI) Sensors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search sensors IC content or ask ...

We are building the Ti Yocto Linux but everytime it gives an error in the following package, gdk-pixbuf_2.42.10. This is the command that we use for the setup: ./oe ...